You're a few steps away from being a DIY Lash QUEEN, follow our next steps for easy, hassle-free beautiful lashes:

1. Clean your lashes with our lash Shampoo and lash brush. Gently tap-dry your lashes with a soft towel.

2. Carefully remove the segments from the tray and set it on a clean surface

3. If you have a lash curler, gently curl your lashes.

4. Apply the lash glue to your natural lashes (like mascara) and to the spine of each segment

5. Look down into a mirror and slight lift your eyelid to place the segment 1-2mm away from your lash line.

6. Hold the lash segment in place for a second to allow it to attach to your natural. If you aren’t happy with the initial placement, gently move the lash segment around to get to your ideal positioning.

7. Leave a few of your natural lashes on the inner and outer corner of your eye free.

8. Wait a minute or 2 for you lashes to try and then, using your fingers, merge the segments with your natural lashes by pressing your natural lashes and the segments together.

9. Once you are happy with the placement, use the round tip of the lash sealant wand to apply lash sealant to where the lashes are bonded. use the wand bristle to apply sealant to the lash fibres

Tips:

- You can use 2-6 segments per eye, depending on the look you are trying to achieve.

- Different lengths can be mixed to create a personalised look.

- If you wear glasses, 10 – 12 mm would be more comfortable.

- Use our lash shampoo and brush to gently cleanse your lashes at the end of each day. This will remove any dirt and oils from your lashes to extend the wear of your lashes.

Once you are ready to remove your lashes,

1. Use our vegan lash shampoo and brush to gently cleanse your lashes.

2. Using our lash remover oil, starting at the area where your lashes are merged together, apply the lash remover like you would mascara.

3. Use your fingers, massage the segments until loosen.

** Do not pull the segments off. **

4. Apply more oil to your natural lashes and use the provide spoolie to brush through your lashes to remove any glue residue left on your natural lashes.

1. Soak lashes in 99% rubbing alcohol for 10 -15 minutes.

2. Remove lashes from the alcohol, 1 at a time and use a dense makeup brush or cotton bud to gently wipe off any glue residue.

3. Dip the cleaned lash in water mixed with a bit of the lash shampoo. Use the lash brush to gently clean any residue from the lashes. Rinse the lashes in plain water and set on a paper towel to try.

4. Brush lashes with a spoolie to fluff up.

5. Made-You-Look lash segments will eventually disintegrate after 2-4 uses.

* Your lashes can last up to 5-10 days and can be re-used 2-4 times before they start to wear out.

* If the segments loosens, add a little glue to the segments and re-apply.

* DO NOT apply the glue all the way to the tips of your lashes.

* Use makeup remover or micellar water to wipe off any glue residue that gets onto the applicator.

* Use a clean cotton bud dipped in micellar water to clean any makeup fallout on top of your lashes after applying make-up